Mopar R8072216AC Rack And Pinion Gear Remanufactured

You can Select Your Vehicle to check if R8072216AC fits your vehicle.

To remove the rack and pinion, drain the power steering pump reservoir and remove the intermediate shaft coupler cover. Also, disconnect the intermediate shaft coupler and remove the wheels. Remove the emissions vapor canister, power steering cooler, tie-rod ends, and subframe/cradle reinforcement plate. To install, center the new rack and pinion, align the index marks on the shafts, and install the mounting bolts. Reinstall the fluid lines, reinforcement bolts, and wheels.

To remove the rack and pinion, drain the power steering pump reservoir and remove the intermediate shaft coupler cover. Also, disconnect the intermediate shaft coupler and remove the wheels. Remove the emissions vapor canister, power steering cooler, tie-rod ends, and subframe/cradle reinforcement plate. To install, center the new rack and pinion, align the index marks on the shafts, and install the mounting bolts. Reinstall the fluid lines, reinforcement bolts, and wheels.

Support and lower the front cross-member to have access to the U-joint. Mark it before taking off the U-joint from the intermediate shaft. The power steering lines can be detached to remove the Rack And Pinion. Also, there is a need to reattach the U-joint and reinstall the Rack And Pinion. Finally, reconnecting the power steering lines, raising the cross member as well as attaching tie rod ends, and installing wheels follow. Resealing of the U-joint will be performed as well as a front-end alignment and test for leaks. Then, you can put on wheels after tie rod ends are fixed by raising the cross member with power steering lines reconnected.