Mopar 5096150AB Fuel Level Unit Kit

You can Select Your Vehicle to check if 5096150AB fits your vehicle.

The fuel level sending unit is secured to the fuel pump housing by a pair of mounting rails on the side of the housing. To remove the sending unit from these two rails you must disengage a pair of locking lugs, located on the underside of the sending unit, that can only be disengaged from the mounting rails by aligning them with the cutouts in the rails. Using an awl or a small screwdriver, carefully lever the lug on the fuel level sending unit toward the area between the two mounting rails until it disengages from the locking lug on the upper rail. Then slide the sending unit to the left until the lugs on the underside of the sending unit are aligned with the cutouts in the mounting rails and lift off the sending unit.

Reinstall the assembly and tighten the locknut securely.

Make alignment marks on the mounting flange and fuel tank for correct realignment during installation.

Depress the release tab and disconnect the electrical connector from the underside of the fuel pump/fuel pressure regulator/fuel level sending unit assembly. Remove the wedge lock from the electrical connector. Using a special terminal removal tool or a suitable substitute, disengage each terminal from the electrical connector and pull out the wire and terminal from the backside of the connector.