Mopar 4781041AB Exhaust Manifold

You can Select Your Vehicle to check if 4781041AB fits your vehicle.

Disconnect the cable from the negative terminal of the battery. For the removal of the rear exhaust manifold, first remove the cowl cover and the wiper unit, then disconnect the rear bank of spark plug wires. Unbolt the crossover pipe where it joins the rear exhaust manifold, disconnect and remove the upstream oxygen sensor connector, and then remove the upstream oxygen sensor. Next, remove the bolts and the upper heat shield, raise the vehicle and support it securely on jackstands, and remove the engine splash shield from the passenger's side. Loosen the power steering pump support strut lower bolt, disconnect the downstream oxygen sensor connector, and remove the bolts to disconnect the catalytic converter from the exhaust manifold. Lower the vehicle and remove the power steering pump support strut upper bolt, then remove the bolts attaching the rear exhaust manifold to the cylinder head and take out the rear exhaust manifold. For the front exhaust manifold, unbolt the crossover pipe where it joins the front exhaust manifold, disconnect the front bank of spark plug wires, remove the bolts and the upper heat shield, and then remove the bolts attaching the front exhaust manifold to the cylinder head. For installation, clean the mating surfaces to remove all traces of old gasket material and inspect the exhaust manifolds for distortion and cracks, checking for warpage with a precision straight edge. If a feeler gauge thicker than 0.030-inch can be inserted between the straightedge and the mating surface, take the exhaust manifold(s) to an automotive machine shop for resurfacing. Place the exhaust manifold in position with a new gasket and install the mounting bolts finger tight, ensuring to identify the exhaust manifold gasket by the correct cylinder designation and the position of the exhaust ports on the gasket. Starting in the middle and working out toward the ends, tighten the bolts to the specified torque. The installation of the remaining components follows the reverse order of removal. Finally, start the engine and check for exhaust leaks between the exhaust manifolds and the cylinder heads, as well as between the exhaust manifolds, crossover pipe, and catalytic converter.

Start the engine and check for exhaust leaks between the exhaust manifolds and the cylinder heads, as well as between the exhaust manifolds, crossover pipe, and catalytic converter.

Clean the exhaust manifold bolts with a wire brush and replace any that are damaged.

Clean the exhaust manifold bolts with a wire brush and replace any that are damaged.

Set the parking brake, block the rear wheels, and raise the front of the vehicle securely on jackstands.

Remove the exhaust manifold nuts and detach the exhaust manifold, discarding old gaskets and cleaning all gasket mating surfaces.

For the front exhaust manifold, take out the coolant reservoir and the dipstick tube.