Mopar 4721550AA Brake Mastr Cylinder

You can Select Your Vehicle to check if 4721550AA fits your vehicle.

To install the new master cylinder, bench bleed it first by mounting it in a vise and attaching bleeder tubes to the outlet ports. Fill the reservoir with recommended brake fluid and slowly push the pistons into the master cylinder to expel air into the reservoir, preventing air from being drawn back in. Remove the bleed tubes, install plugs, and the reservoir cap. Put a new vacuum seal on the master cylinder where it mates with the power booster. Install the master cylinder over the power brake booster studs and finger-tighten the nuts. Thread the brake line fittings into the master cylinder, ensuring they don't strip. Fully tighten the mounting nuts and brake line fittings. Fill the reservoir with fluid, then bleed the master cylinder and brake system with an assistant. Loosen the fittings, allowing air and fluid to escape, and repeat this on both fittings until the fluid is clear of air bubbles. Use rags to catch spilled brake fluid to avoid damaging painted surfaces. After bleeding, rinse the area under the master cylinder with clean water. Finally, test the brake system's operation carefully before normal vehicle use.

To install the new master cylinder, bench bleed it first by mounting it in a vise and attaching bleeder tubes to the outlet ports. Fill the reservoir with recommended brake fluid and slowly push the pistons into the master cylinder to expel air into the reservoir, preventing air from being drawn back in. Remove the bleed tubes, install plugs, and the reservoir cap. Put a new vacuum seal on the master cylinder where it mates with the power booster. Install the master cylinder over the power brake booster studs and finger-tighten the nuts. Thread the brake line fittings into the master cylinder, ensuring they don't strip. Fully tighten the mounting nuts and brake line fittings. Fill the reservoir with fluid, then bleed the master cylinder and brake system with an assistant. Loosen the fittings, allowing air and fluid to escape, and repeat this on both fittings until the fluid is clear of air bubbles. Use rags to catch spilled brake fluid to avoid damaging painted surfaces. After bleeding, rinse the area under the master cylinder with clean water. Finally, test the brake system's operation carefully before normal vehicle use.

When replacing the master cylinder, position a container and layers of newspaper underneath it to catch any spilled brake fluid. Proceed to unscrew the steel line flare nuts, remove the lines, and cap them. Allow the fluid in the master cylinder to drain into the container. Then, remove the mounting nuts and detach the master cylinder from the booster. If a new master cylinder is being installed, it may be necessary to transfer the plastic fluid reservoir.