Mopar V1109148AA Brake Mastr Cylinder

You can Select Your Vehicle to check if V1109148AA fits your vehicle.

To install the new master cylinder, bench bleed it before installing by mounting it in a vise and attaching a pair of master cylinder bleeder tubes to the outlet ports, fill the reservoir with brake fluid and slowly push the pistons into the master cylinder using a large Phillips screwdriver to expel air from the pressure chambers, repeat this procedure until no more air bubbles are present and remove the bleed tubes, installing plugs in the open ports to prevent fluid leakage and air from entering, install a new vacuum seal on the master cylinder and then install the reservoir cover, install the master cylinder over the studs on the power brake booster and tighten the attaching nuts finger tight, thread the brake line fittings into the master cylinder, being careful not to strip the threads, and tighten the mounting nuts and brake line fittings securely, fill the master cylinder reservoir with the correct fluid and bleed the brake system as described, and finally, test the operation of the brake system carefully before placing the vehicle into normal service.