Mopar 68036940AD Package-Steering

You can Select Your Vehicle to check if 68036940AD fits your vehicle.

For vehicles with link/coil suspension, follow these steps:Loosen the wheel lug nuts.Raise the vehicle and support it securely on jackstands.Measure the distance between the adjuster tube and the center line of the ball stud for toe-in reference.Loosen the nut on the tie-rod end ball stud and disconnect it from the steering knuckle arm using a puller.If replacing the tie-rod end, lubricate the threaded portion, and install the new one into the adjuster tube to match the previous measurement.Insert the tie-rod ball stud into the steering knuckle, fully seat it, and tighten the nut.Tighten the tie-rod adjuster clamp bolts.Have the front end alignment checked and adjusted if necessary.

For removing and installing the drag link, follow these steps:Loosen the wheel lug nuts.Raise the vehicle and securely support it on jackstands.Remove the nut from the drag link ball stud.Use a puller to separate the drag link from the Pitman arm.Loosen the nuts on the tie-rod end ball studs.Disconnect the tie-rod ends from the steering knuckle and drag link with a puller.Installation is the reverse of removal, and ensure all fasteners are tightened.Have the front end alignment checked and adjusted if necessary.