Mopar 4782524AF Power Steering Pump

You can Select Your Vehicle to check if 4782524AF fits your vehicle.

Disconnect the cable from the negative battery terminal. Using a large syringe or suction gun, suck as much fluid out of the power steering fluid reservoir as possible. Remove the air filter housing. Remove the drivebelt. Position a drain pan under the power steering pump, then disconnect the pressure line and the supply hose. Plug the openings to prevent excessive fluid loss and the entry of contaminants. Remove the pump mounting bolts. The bolts can be accessed through the holes in the power steering pump pulley. Lift the pump from the engine compartment, being careful not to let any power steering fluid drip on the vehicle's paint. Note: The pulley can be removed from the pump if necessary. Special tools for this are available at most auto parts stores. Installation is the reverse of removal. Be sure to tighten all fasteners securely. Fill the power steering reservoir with the recommended fluid and bleed the system. Re-check the power steering fluid level.

Re-check the power steering fluid level.

Using a large syringe or suction gun, suck as much fluid out of the power steering fluid reservoir as possible.