Mopar 4894016AB Front Door Window Regulator

You can Select Your Vehicle to check if 4894016AB fits your vehicle.

In order to service the front door, start by popping the door trim panel, the watershield and the door glass. In case of power windows models, pull off the electrical connector. Subsequently, unscrew the keyhole slots which fas TEN the front and rear guide rails of the door panel to the regulator as well as the screw heads of the guide rails from the door panel. To remove the regulator pull the regulator up to unlock it and then slide it to the rear end and then pull through the hole in the door. The front guide rail can be taken off from the front aperture and the rear guide rail is also taken off from the rear aperture. This is in the reverse order to the removal process Installation takes. Starting for the quarter window, the procedure involves the process of disconnecting that electrical connector on the vent motor and also the removal of rear trim panel. Subsequently, take out the circular actuator link tab and disconnect the arm from the window ball socket. Then pull out the vent motor mounting screws and take out the vent motor and the process of installation is also vice versa.

Remove the screw heads on the guide rails from the keyhole slots in the door panel.

Installation is the reverse of removal in all cases.