Mopar 4886260AB Sensor-Shock

You can Select Your Vehicle to check if 4886260AB fits your vehicle.

Loosen the wheel lug nuts.

Support the axle with a floor jack.

Extend the damper rod to its full length and install the rubber bumper. Install the dust boot onto the damper. Carefully place the coil spring onto the damper, aligning it with the reference marks made during disassembly. Install the upper spring isolator and seat onto the damper shaft, again noting reference marks. Install the upper mount to the damper shaft, noting its alignment. Install the nut on the damper shaft and tighten it. Loosen the coil spring compressor until the top coil is properly seated against the upper spring seat and upper mount. Relieve all tension from the spring compressor and remove the tool from the coil spring. Finally, install the strut/spring assembly.

Complete strut assemblies may be available on an exchange basis, which eliminates much time and work.

Separate the strut from the steering knuckle.

Block the front wheels to prevent the vehicle from moving.

You'll need a spring compressor.

Reconnect the fitting for the height sensor.

Attach the strut to the steering knuckle, then insert the strut-to-steering knuckle bolts through the cam and washer plate. Install the nuts, but don't tighten them yet.