Mopar 5096057AA SENSORPKG-CAMSHAFT

You can Select Your Vehicle to check if 5096057AA fits your vehicle.

Disconnect the negative battery cable. The CMP sensor is located on the left end of the cylinder head; to release the locking tab on the CMP sensor electrical connector, push it out toward the firewall. If necessary, move the brake booster hose and any electrical wires out of the way to access the CMP sensor. Disconnect the CMP sensor electrical connector. Remove the CMP sensor retaining bolts to detach the CMP sensor from the cylinder head, and then remove the CMP sensor. Remove the Torx bolt that attaches the target magnet to the camshaft to detach the CMP sensor target magnet from the end of the camshaft, and then remove the target magnet. When installing the target magnet, ensure that the locating dowels on the back of the magnet are aligned with the machined locating holes in the end of the camshaft, and tighten the target magnet retaining screw to the specified torque. If planning to install the old CMP sensor, inspect the O-ring on the sensor mounting plate; if it's cracked, torn, or deteriorated, replace it. If installing a new CMP sensor, ensure a new O-ring is already installed. Installation is otherwise the reverse of removal, and be sure to tighten the CMP sensor retaining bolts to the specified torque.