Mopar 52069887AD Axle Shaft

You can Select Your Vehicle to check if 52069887AD fits your vehicle.

After removing the driveaxle/hub nut, you should remove the hub bearing and brake shield. Following that, you'll need to use a prybar or slide hammer with a CV joint adapter to pry the inner CV joint assembly from the front differential.

Before assuming an axle problem, a thorough check should be performed as noises commonly associated with axle diagnosis procedures can be caused by road surface, tire wear or pressure, or engine and transmission issues.

Clean off all traces of old gasket material from the differential cover and axle housing, then apply a bead of RTV sealant to the cover. Install the cover and bolts, tightening the bolts.

Start by raising the rear of the vehicle and supporting it with jackstands. Remove the rear wheels and disconnect the driveshaft and ABS sensor. Disconnect the parking brake cable and unscrew the vent hose fitting. Disconnect the brake lines and remove the rear brake calipers. Support the rear axle with a floor jack and remove the Watts link bellcrank bolt and stabilizer bar clamp bolts. Remove the lower mounting bolts securing the rear shocks and the upper control arms from the axle brackets. Lower the axle assembly and remove the coil springs. Remove the lower control arms and lower the axle assembly from under the vehicle.