Mopar 5146495AA Rear Drive Shaft

You can Select Your Vehicle to check if 5146495AA fits your vehicle.

The rear driveshaft employs a splined yoke at the front, which slips into the extension housing of the transmission.

The first step in the process is to raise the vehicle and support it securely on jack stands.

To install the driveshaft, remove the plastic bag from the transmission or transfer case extension housing and wipe the area clean. Inspect the oil seal and center support bearing. Insert the front end of the driveshaft assembly into the transmission or transfer case extension housing. Raise the rear of the driveshaft into position, checking the alignment marks. If it's a two-piece unit, raise the center support bearing and bolt it loosely into place. Raise the rear end of the rear shaft into position and make sure the alignment marks are in alignment. Remove the tape securing the bearing caps and install the clamps and fasteners.