Mopar 52105982AC Drive Shaft

You can Select Your Vehicle to check if 52105982AC fits your vehicle.

Raise and secure the vehicle on jack stands. Mark the driveshaft's alignment with the differential axle assembly flange before removing the bolts. Lower the driveshaft and slide the front end out of the transmission housing. For two-piece driveshafts, mark and unbolt the center support bearing before sliding the front end out. Cover the extension housing with a plastic bag to prevent fluid loss. During installation, check and replace the oil seal and center support bearing if necessary. Ensure alignment marks match when inserting the driveshaft. For 4WD models, remove the skid plate and exhaust crossover pipe if necessary, mark alignment, unbolt the flange, and remove the driveshaft. Ensure proper alignment during installation.

It is sometimes better to have the universal joints replaced by a dealership or shop specializing in this type of work.