Mopar 52123150AC Rear Drive Shaft

You can Select Your Vehicle to check if 52123150AC fits your vehicle.

When applying the lubricant, you should avoid applying so much that an excessive amount comes out.

Wrap a plastic bag over the extension housing and hold it in place with a rubber band.

When the vehicle is raised for service, it's a good idea to clean the driveshaft and inspect it for any obvious damage. Also, make sure the small weights used to originally balance the driveshaft are in place and securely attached.

The rear driveshaft employs a splined yoke at the front, which slips into the extension housing of the transmission.

If it's a two-piece driveshaft, mark the relationship of the center support bearing to the support bracket, then unbolt the center support bearing and slide the front end of the front driveshaft out of the extension housing.

After raising the vehicle, you should clean the grease fitting on the front driveshaft with a rag.

After applying the lubricant, you should wipe any extra grease and dirt from the area with a rag.

To install the driveshaft, remove the plastic bag from the transmission or transfer case extension housing and wipe the area clean. Inspect the oil seal and center support bearing. Insert the front end of the driveshaft assembly into the transmission or transfer case extension housing. Raise the rear of the driveshaft into position, checking the alignment marks. If it's a two-piece unit, raise the center support bearing and bolt it loosely into place. Raise the rear end of the rear shaft into position and make sure the alignment marks are in alignment. Remove the tape securing the bearing caps and install the clamps and fasteners.

After applying the lubricant, you should wipe any extra grease and dirt from the area with a rag.

The rear driveshaft employs a splined yoke at the front, which slips into the extension housing of the transmission.

Wrap a plastic bag over the extension housing and hold it in place with a rubber band.

Three different types of universal joints are used: single-cardan, double-cardan, and constant velocity.