Mopar 52123157AD Rear Drive Shaft

You can Select Your Vehicle to check if 52123157AD fits your vehicle.

After raising the vehicle, you should clean the grease fitting on the front driveshaft with a rag.

To install the driveshaft, remove the plastic bag from the transmission or transfer case extension housing and wipe the area clean. Inspect the oil seal and center support bearing. Insert the front end of the driveshaft assembly into the transmission or transfer case extension housing. Raise the rear of the driveshaft into position, checking the alignment marks. If it's a two-piece unit, raise the center support bearing and bolt it loosely into place. Raise the rear end of the rear shaft into position and make sure the alignment marks are in alignment. Remove the tape securing the bearing caps and install the clamps and fasteners.

Some models have a two-piece driveshaft, where two drive shafts are connected at a center support bearing.