Mopar 52123161AB Rear Drive Shaft

You can Select Your Vehicle to check if 52123161AB fits your vehicle.

Problems with the driveshaft are usually indicated by a noise or vibration while driving the vehicle.

Factory U-joints are lubricated for life and must be replaced if problems develop.

After applying the lubricant, you should wipe any extra grease and dirt from the area with a rag.

If it's a one-piece unit, slide the front end of the driveshaft out of the transmission extension housing.

After applying the lubricant, you should wipe any extra grease and dirt from the area with a rag.

To install the driveshaft, remove the plastic bag from the transmission or transfer case extension housing and wipe the area clean. Inspect the oil seal and center support bearing. Insert the front end of the driveshaft assembly into the transmission or transfer case extension housing. Raise the rear of the driveshaft into position, checking the alignment marks. If it's a two-piece unit, raise the center support bearing and bolt it loosely into place. Raise the rear end of the rear shaft into position and make sure the alignment marks are in alignment. Remove the tape securing the bearing caps and install the clamps and fasteners.