Mopar 52123327AB Front Drive Shaft

You can Select Your Vehicle to check if 52123327AB fits your vehicle.

A conventional grease gun should be used to apply sufficient lubricant to the fitting.

A driveshaft is a tube that transmits power between the transmission or transfer case and the differential(s).

To install the driveshaft, remove the plastic bag from the transmission or transfer case extension housing and wipe the area clean. Inspect the oil seal and center support bearing. Insert the front end of the driveshaft assembly into the transmission or transfer case extension housing. Raise the rear of the driveshaft into position, checking the alignment marks. If it's a two-piece unit, raise the center support bearing and bolt it loosely into place. Raise the rear end of the rear shaft into position and make sure the alignment marks are in alignment. Remove the tape securing the bearing caps and install the clamps and fasteners.

An oil seal prevents fluid from leaking out of the extension housing and keeps dirt from entering the transmission or transfer case. If leakage is evident at the front of the driveshaft, the extension housing oil seal should be replaced.

After applying the lubricant, you should wipe any extra grease and dirt from the area with a rag.

If it's a two-piece driveshaft, mark the relationship of the center support bearing to the support bracket, then unbolt the center support bearing and slide the front end of the front driveshaft out of the extension housing.