Mopar 68034650AA Rear Drive Shaft

You can Select Your Vehicle to check if 68034650AA fits your vehicle.

When applying the lubricant, you should avoid applying so much that an excessive amount comes out.

To install the driveshaft, remove the plastic bag from the transmission or transfer case extension housing and wipe the area clean. Inspect the oil seal and center support bearing. Insert the front end of the driveshaft assembly into the transmission or transfer case extension housing. Raise the rear of the driveshaft into position, checking the alignment marks. If it's a two-piece unit, raise the center support bearing and bolt it loosely into place. Raise the rear end of the rear shaft into position and make sure the alignment marks are in alignment. Remove the tape securing the bearing caps and install the clamps and fasteners.

The first step in the process is to raise the vehicle and support it securely on jack stands.

The manufacturer recommends replacing driveshaft fasteners with new ones.

Problems with the driveshaft are usually indicated by a noise or vibration while driving the vehicle.

Some models have a two-piece driveshaft, where two drive shafts are connected at a center support bearing.