Mopar 68034651AA Rear Drive Shaft

You can Select Your Vehicle to check if 68034651AA fits your vehicle.

To replace the rear driveshaft, lift the vehicle and mark the driveshaft's position. Remove the bolts securing the driveshaft to the differential pinion flange. Pry the universal joint away and lower the driveshaft. If it's a one-piece, slide it out of the transmission housing; if it's a two-piece, mark the center support bearing's position, unbolt it, and slide the front end out. Cover the extension housing with a plastic bag. To install, remove the bag, clean the area, and inspect the oil seal and center support bearing. Insert the driveshaft into the housing, raise it into position, and check alignment marks. If it's a two-piece, loosely bolt the center support bearing. Raise the rear end, align marks, remove tape from bearing caps, and install clamps and fasteners. For 4WD models, mark the driveshaft's position, remove bolts and straps, make alignment marks, unbolt the flange, and remove the driveshaft.

The first step in the process is to raise the vehicle and support it securely on jack stands.

Problems with the driveshaft are usually indicated by a noise or vibration while driving the vehicle.

When applying the lubricant, you should avoid applying so much that an excessive amount comes out.

To remove the rear driveshaft, raise the vehicle and mark the relationship of the driveshaft to the differential axle assembly mating flange or yoke. Remove the bolts securing the driveshaft flange or universal joint clamps to the differential pinion flange or yoke. Pry the universal joint away from its mating flange or yoke and lower the rear of the driveshaft.

Problems with the driveshaft are usually indicated by a noise or vibration while driving the vehicle.