Mopar 4656305 Front Coil Spring

You can Select Your Vehicle to check if 4656305 fits your vehicle.

Start by removing it and reinstalling the clevis bracket on the shock absorber. Clamp the shock absorber in a vertical position in a vise. Next, compress the coil spring using a coil spring compressor and remove the shock absorber damper rod nut. Take off the damper rod washer, upper control arm mounting bracket, and isolator bushings from the damper rod. Remove the shock absorber upper isolator bushing, lower isolator bushing, and sleeve from the upper control arm mounting bracket. Then, remove the upper spring isolator from the mounting bracket and the lower isolator bushing from the damper rod sleeve. Remove the washer and dust shield from the shock absorber assembly, followed by the compressed coil spring. Take off the jounce bumper and sleeve from the shock absorber assembly, as well as the coil spring isolator from the lower spring seat on the shock absorber.

Check for leaking fluid, dents, cracks, and other obvious damage. Also, check the coil spring for chips and corrosion. Replace any damaged components.

Start by rolling back the trunk carpeting and removing the plastic cap to access the upper shock mounting bolts. Then, lift the carpeting and unsnap the plastic cover to remove the two upper mounting nuts. Next, loosen the rear wheel lug nuts, raise the vehicle, and support it on jackstands. Remove the rear wheels and the shock absorber lower mounting bolt from the rear knuckle. Push down on the rear suspension and pull the shock away from the knuckle to remove it.