Mopar 52122559AA Front Coil Spring

You can Select Your Vehicle to check if 52122559AA fits your vehicle.

During the installation of the coil spring, start by placing the insulator on top of the coil spring. Install the top of the spring into the spring pocket and the bottom of the spring into the lower control arm. After this, reconnect the lower control arm to the steering knuckle. Following the successful installation of the coil spring, you can remove the spring compressor. The rest of the installation process should follow the reverse of the removal steps. Make sure to tighten all fasteners to their proper torque values and also tighten the wheel lug nuts. Lastly, it's advisable to have the front end alignment checked and adjusted if necessary.

Place a jack under the rear axle to support its weight, remove the bolt from the lower shock absorber mount, and slowly lower the jack until the spring and insulator can be pulled out.

Reverse the removal process and tighten all fasteners.

To begin the process of removing the coil spring on models with independent front suspension (except 1500 4WD models), start by loosening the wheel lug nuts. After that, raise the vehicle and make sure to securely support it on jackstands placed under the frame rails. Following the secure setup, proceed to remove the wheel.