Mopar 5272621AF Front Coil Springs

You can Select Your Vehicle to check if 5272621AF fits your vehicle.

To disassemble the strut and spring assembly, you need to mount the strut clevis bracket portion in a vise and mark the components for reassembly. Then, install a spring compressor on the spring and compress it to relieve pressure from the upper mount. While holding the damper shaft, loosen the shaft nut with a socket. Remove the nut and upper mount, inspecting the pivot bearing and upper spring seat for damage. Lift the compressed spring from the assembly and remove the dust boot from the damper shaft. Slide the rubber bumper off the damper shaft and check the lower spring isolator for damage.

For 2015 and later models, the initial steps involve raising the rear of the vehicle and supporting it on jackstands, removing the wheels, and removing the rear fenderwell splash shield.

If equipped, the trim panels covering the lower control arm should also be removed.

Some signs of wear include leaking fluid, loss of damping capability, and chipped, sagging, or cracked coil springs.

Compress the coil spring with a spring compressor, following the tool manufacturer's instructions. Compress the spring until tension is removed from the upper bracket.

Slowly release tension from the spring by backing off the spring compressor. Ensure the spring has settled in the locator holes and the brackets/mounts are not twisted or off-center.