Mopar 5272623AF Front Coil Spring

You can Select Your Vehicle to check if 5272623AF fits your vehicle.

Install the shock absorber/coil spring assembly.

A floor jack should be used to support the knuckle and raise it slightly.

Remove the shock through the bottom of the spring and inspect all parts for damage. Install the parts on the new shock in the correct order. Install the washer and damper shaft nut, tightening it while holding the damper shaft with a wrench.

Some signs of wear include leaking fluid, loss of damping capability, and chipped, sagging, or cracked coil springs.

To disassemble the strut and spring assembly, you need to mount the strut clevis bracket portion in a vise and mark the components for reassembly. Then, install a spring compressor on the spring and compress it to relieve pressure from the upper mount. While holding the damper shaft, loosen the shaft nut with a socket. Remove the nut and upper mount, inspecting the pivot bearing and upper spring seat for damage. Lift the compressed spring from the assembly and remove the dust boot from the damper shaft. Slide the rubber bumper off the damper shaft and check the lower spring isolator for damage.

After removing the trim panels, the rear wheel lug nuts should be loosened, the vehicle should be raised and supported on jackstands, and the rear wheels should be removed.