Mopar 5272627AC Front Coil Spring

You can Select Your Vehicle to check if 5272627AC fits your vehicle.

To disassemble the strut and spring assembly, you need to mount the strut clevis bracket portion in a vise and mark the components for reassembly. Then, install a spring compressor on the spring and compress it to relieve pressure from the upper mount. While holding the damper shaft, loosen the shaft nut with a socket. Remove the nut and upper mount, inspecting the pivot bearing and upper spring seat for damage. Lift the compressed spring from the assembly and remove the dust boot from the damper shaft. Slide the rubber bumper off the damper shaft and check the lower spring isolator for damage.

Compress the coil spring with a spring compressor, following the tool manufacturer's instructions. Compress the spring until tension is removed from the upper bracket.

On 2015 and later models, the shock absorber upper bolts should be tightened.

Hold the damper shaft with a wrench and remove the damper shaft nut.

To reassemble the strut and spring assembly, you need to extend the damper rod and install the rubber bumper. Put the dust boot onto the damper and carefully place the coil spring onto the damper, aligning it with the reference marks made during disassembly. Install the upper spring isolator and seat, followed by the upper mount, and tighten the nut on the damper shaft. Loosen the coil spring compressor until the top coil is properly seated against the upper spring seat and upper mount. Finally, remove the tool from the coil spring and install the strut/spring assembly.

For 2015 and later models, the initial steps involve raising the rear of the vehicle and supporting it on jackstands, removing the wheels, and removing the rear fenderwell splash shield.