Mopar 5272731AD Front Coil Springs

You can Select Your Vehicle to check if 5272731AD fits your vehicle.

Slowly release tension from the spring by backing off the spring compressor. Ensure the spring has settled in the locator holes and the brackets/mounts are not twisted or off-center.

The trim panels from the sides of the trunk should be removed to access the shock absorber upper mounting fasteners.

Before starting any work, it is recommended to explore all options. The strut body cannot be serviced and must be replaced if there is a problem. However, complete strut assemblies with springs may be available on an exchange basis, which can save time and effort. It is important to check the cost and availability of parts before disassembling the vehicle.

Compress the coil spring with a spring compressor, following the tool manufacturer's instructions. Compress the spring until tension is removed from the upper bracket.

The shock absorber lower mounting nut and bolt should be removed to take out the shock unit.

To reassemble the strut and spring assembly, you need to extend the damper rod and install the rubber bumper. Put the dust boot onto the damper and carefully place the coil spring onto the damper, aligning it with the reference marks made during disassembly. Install the upper spring isolator and seat, followed by the upper mount, and tighten the nut on the damper shaft. Loosen the coil spring compressor until the top coil is properly seated against the upper spring seat and upper mount. Finally, remove the tool from the coil spring and install the strut/spring assembly.