Mopar 5272732AE Front Coil Spring

You can Select Your Vehicle to check if 5272732AE fits your vehicle.

After removing the trim panels, the rear wheel lug nuts should be loosened, the vehicle should be raised and supported on jackstands, and the rear wheels should be removed.

To disassemble the strut and spring assembly, you need to mount the strut clevis bracket portion in a vise and mark the components for reassembly. Then, install a spring compressor on the spring and compress it to relieve pressure from the upper mount. While holding the damper shaft, loosen the shaft nut with a socket. Remove the nut and upper mount, inspecting the pivot bearing and upper spring seat for damage. Lift the compressed spring from the assembly and remove the dust boot from the damper shaft. Slide the rubber bumper off the damper shaft and check the lower spring isolator for damage.

Compress the coil spring with a spring compressor, following the tool manufacturer's instructions. Compress the spring until tension is removed from the upper bracket.

To disassemble the strut and spring assembly, you need to mount the strut clevis bracket portion in a vise and mark the components for reassembly. Then, install a spring compressor on the spring and compress it to relieve pressure from the upper mount. While holding the damper shaft, loosen the shaft nut with a socket. Remove the nut and upper mount, inspecting the pivot bearing and upper spring seat for damage. Lift the compressed spring from the assembly and remove the dust boot from the damper shaft. Slide the rubber bumper off the damper shaft and check the lower spring isolator for damage.

The lower mount of the shock absorber should be greased with white lithium grease for easier installation and to prolong the life of the lower shock bushing.

For coil spring models, raise the rear of the vehicle on jackstands and remove the wheels. Disconnect the stabilizer bar link from the lower control arm. Use a floor jack to support the knuckle and raise it slightly. Remove the lower control arm-to-knuckle bolt and nut. Lower the control arm slowly to remove the spring. Installation is the reverse of removal.