Mopar 68050565AA Front Coil Spring

You can Select Your Vehicle to check if 68050565AA fits your vehicle.

During the removal process, you should disconnect the stabilizer bar link from the lower control arm. You'll also need to separate the lower control arm from the steering knuckle.

During the installation of the coil spring, start by placing the insulator on top of the coil spring. Install the top of the spring into the spring pocket and the bottom of the spring into the lower control arm. After this, reconnect the lower control arm to the steering knuckle. Following the successful installation of the coil spring, you can remove the spring compressor. The rest of the installation process should follow the reverse of the removal steps. Make sure to tighten all fasteners to their proper torque values and also tighten the wheel lug nuts. Lastly, it's advisable to have the front end alignment checked and adjusted if necessary.

Place a jack under the rear axle to support its weight, remove the bolt from the lower shock absorber mount, and slowly lower the jack until the spring and insulator can be pulled out.

Place a jack under the rear axle to support its weight, remove the bolt from the lower shock absorber mount, and slowly lower the jack until the spring and insulator can be pulled out.

Reverse the removal process and tighten all fasteners.

Once the knuckle and hub assembly is supported by the block of wood, you should lower the floor jack. This will allow you to guide the compressed coil spring out from its position.

During the installation of the coil spring on models with a solid front axle, follow the reverse of the removal steps. Ensure all components are properly connected and fastened.

Place a jack under the rear axle to support its weight, remove the bolt from the lower shock absorber mount, and slowly lower the jack until the spring and insulator can be pulled out.