Mopar 68050581AA Front Coil Spring

You can Select Your Vehicle to check if 68050581AA fits your vehicle.

Reverse the removal process and tighten all fasteners.

During the removal process, you should disconnect the stabilizer bar link from the lower control arm. You'll also need to separate the lower control arm from the steering knuckle.

After raising the vehicle and securely supporting it on jackstands, remove the wheels. Then, use floor jacks to support the end of the axle from which you're removing the spring. Install a coil spring compressor on the coil spring and slightly compress the spring. Following this, remove the upper suspension arm and loosen the lower suspension arm nuts and pivot bolts. Additionally, mark and disconnect the front driveshaft from the front axle. Disconnect the track bar from the frame rail bracket, the drag link from the Pitman arm, and the stabilizer bar link from the axle. Finally, disconnect the shock absorber from the axle and lower the axle until the coil spring is free for removal.

Place a jack under the rear axle to support its weight, remove the bolt from the lower shock absorber mount, and slowly lower the jack until the spring and insulator can be pulled out.

After the wheel is removed, you'll need to use a floor jack to support the outer end of the lower control arm. This step is crucial to ensure stability during the removal process.

During the installation of the coil spring on models with a solid front axle, follow the reverse of the removal steps. Ensure all components are properly connected and fastened.

Reverse the removal process and tighten all fasteners.

Reverse the removal process and tighten all fasteners.