Mopar 68050582AA Front Coil Spring

You can Select Your Vehicle to check if 68050582AA fits your vehicle.

Reverse the removal process and tighten all fasteners.

During the installation of the coil spring, start by placing the insulator on top of the coil spring. Install the top of the spring into the spring pocket and the bottom of the spring into the lower control arm. After this, reconnect the lower control arm to the steering knuckle. Following the successful installation of the coil spring, you can remove the spring compressor. The rest of the installation process should follow the reverse of the removal steps. Make sure to tighten all fasteners to their proper torque values and also tighten the wheel lug nuts. Lastly, it's advisable to have the front end alignment checked and adjusted if necessary.

Certainly. After separating the lower control arm from the steering knuckle, lift the knuckle and hub assembly upward. Then, place a block of wood between the upper control arm and the frame. This action supports the assembly and keeps it out of the way for further steps.

Reverse the removal process and tighten all fasteners.

Place a jack under the rear axle to support its weight, remove the bolt from the lower shock absorber mount, and slowly lower the jack until the spring and insulator can be pulled out.

Place a jack under the rear axle to support its weight, remove the bolt from the lower shock absorber mount, and slowly lower the jack until the spring and insulator can be pulled out.

During the installation of the coil spring on models with a solid front axle, follow the reverse of the removal steps. Ensure all components are properly connected and fastened.

To begin the process of removing the coil spring on models with independent front suspension (except 1500 4WD models), start by loosening the wheel lug nuts. After that, raise the vehicle and make sure to securely support it on jackstands placed under the frame rails. Following the secure setup, proceed to remove the wheel.