Mopar 68068585AA Front Coil Spring

You can Select Your Vehicle to check if 68068585AA fits your vehicle.

To begin the process of removing the coil spring on models with independent front suspension (except 1500 4WD models), start by loosening the wheel lug nuts. After that, raise the vehicle and make sure to securely support it on jackstands placed under the frame rails. Following the secure setup, proceed to remove the wheel.

After raising the vehicle and securely supporting it on jackstands, remove the wheels. Then, use floor jacks to support the end of the axle from which you're removing the spring. Install a coil spring compressor on the coil spring and slightly compress the spring. Following this, remove the upper suspension arm and loosen the lower suspension arm nuts and pivot bolts. Additionally, mark and disconnect the front driveshaft from the front axle. Disconnect the track bar from the frame rail bracket, the drag link from the Pitman arm, and the stabilizer bar link from the axle. Finally, disconnect the shock absorber from the axle and lower the axle until the coil spring is free for removal.

During the installation of the coil spring on models with a solid front axle, follow the reverse of the removal steps. Ensure all components are properly connected and fastened.

Reverse the removal process and tighten all fasteners.

Place a jack under the rear axle to support its weight, remove the bolt from the lower shock absorber mount, and slowly lower the jack until the spring and insulator can be pulled out.

Reverse the removal process and tighten all fasteners.