Mopar 5181369AC Rear Coil Spring

You can Select Your Vehicle to check if 5181369AC fits your vehicle.

These vehicle models are equipped with shock absorber/coil spring assemblies, allowing for individual replacement of shocks or springs, though disassembly by a qualified repair shop with proper equipment is necessary, which can significantly increase project costs. For SRT models, a unique front shock absorber system uses several accelerometers to monitor the shock, with the ADS "Active Damping System" adjusting the shocks based on road conditions and vehicle angle through the ADCM "Active Damping Control Module." The ADS shock absorber is serviced similarly to non-SRT models, except for disconnecting three wire electrical connections from the shock. To remove the shock absorber, first, take off the cap on the shock tower (if equipped) and remove the fasteners attaching the upper end of the shock to the frame. Next, loosen the front wheel lug nuts, raise the front of the vehicle, and support it securely on jackstands before removing the front wheels. Disconnect the stabilizer bar link from the shock assembly, then remove the fasteners attaching the lower end of the shock absorber to the lower control arm. Pull down on the lower control arm and remove the shock absorber toward the rear of the vehicle. Inspect the shock absorber for leaking fluid, dents, cracks, and other damage, as well as the coil spring for chips and cracks that could lead to premature failure, and check the spring seats for hardness and deterioration. If any components are worn or damaged, have the unit serviced or replaced by a qualified repair shop. For installation, raise the lower control arm with a floor jack to simulate normal ride height before tightening the lower shock absorber mounting fasteners, then install in reverse order of removal and ensure all mounting fasteners and wheel lug nuts are tightened to the specified torque.

Raise the spring link with a floor jack to simulate normal ride height before tightening the toe link mounting fasteners, using a wood block and floor jack for support or elevation.