Mopar 4896464AE Engine Starter

You can Select Your Vehicle to check if 4896464AE fits your vehicle.

To prepare for removing the starter, follow these initial steps: Disconnect the cable from the negative terminal of the battery. Raise the vehicle and ensure it is securely supported on jack stands. Remove the middle engine splash shield. Secure the steering wheel to prevent it from rotating freely.

Loosen the lug nuts on the left front wheel. Raise the vehicle and place it securely on jackstands. Remove the wheel. Remove the splash shield from the left front wheel housing. Remove the starter heat shield and fasteners, if equipped. Disconnect the battery cable and electrical connector from the terminals on the starter motor solenoid. Remove the two starter motor mounting bolts and remove the starter motor assembly.

Remove the starter from the engine and bench test the starter. If the starter turns over slowly, check the starter cranking voltage and the current draw from the battery. This test must be performed with the starter assembly on the engine. Crank the engine over (for 10 seconds or less) and observe the battery voltage. It should not drop below 9.6 volts. Also, observe the current draw with an ammeter (Use an inductive ammeter to measure starter current draw). Typically a starter should not exceed 160 amps. If the starter motor amperage draw is excessive, have it tested by a dealer service department or other qualified repair shop.