Mopar 5269625 Switch-Power Steering

You can Select Your Vehicle to check if 5269625 fits your vehicle.

Remove the cable that is connected to the negative terminal of the battery, then, lift the car and support it on safety stands. Subsequently, remove the electrical connector from the power steering fluid pressure switch. To achieve this, the power steering fluid pressure switch should be loosened by having a deep socket and an extension to unscrew and then remove it. Thread the new switch and seal it with the Teflon tape thereafter; installation is just the opposite of removal with a lot of emphasis on switch tightness.

Remove the negative battery clasp; thereafter, lift the car and support it on stands. Next, remove the electrical connector for the power steering fluid pressure switch which is a part of power steering gear assembly; to do this release the locking tab at the top of the connector and pry it off. With the use of a 7/8-inch deep socket and an extension, loosen and take off the power steering fluid pressure switch, but be careful that the deep socket cover the plastic connector. Finally, to seal the threads of the new switch, use the Teflon tape while for the installation process one has to follow the reverse procedure to the removal in as much as tightening the switch to the right torque as recommended is paramount.