Mopar 5171127AD Tube-Brake

You can Select Your Vehicle to check if 5171127AD fits your vehicle.

When replacing metal brake lines, use prefabricated brake lines with flared tube ends and installed fittings. These lines can be bent to the proper shapes using a tubing bender. Make sure the new line is well supported in brackets and has sufficient clearance from moving or hot components. Tighten the fittings securely.

When replacing a flexible brake hose, follow these steps:Clean dirt from the hose and line fittings.Disconnect the metal brake line from the hose fitting using a flare-nut wrench, and plug the metal line to prevent leakage and contamination.Remove the clip retaining the brake hose to the bracket and the bolt retaining the brake hose bracket to the strut.Unscrew the banjo bolt at the caliper and remove the hose, discarding the sealing washers.Attach the new brake hose to the caliper, using new sealing washers, and tighten the banjo bolt to the specified torque.Attach the brake hose bracket to the strut, ensuring the hose isn't kinked or twisted.Connect the hose to the chassis bracket, and install the retaining clip.Reconnect the metal line to the hose fitting, tightening it securely.Repeat the same steps for rear brake hose replacement.