Mopar EC28LB7 Wheel-Steering

You can Select Your Vehicle to check if EC28LB7 fits your vehicle.

First, twist anticlockwise the horn button to disconnect it or if the horn requires the pad to be taken then unscrew two screws present in the base of it. Subsequently, the horn wire ought to be withdrawn from the switch terminal and three screws must be unscrewed in order to take out the horn switch and button or the pad retainer assembly. After that you remove the steering wheel retainer nut and then using a puller like the Dodge/Plymouth No. C-34288, withdrawing the steering wheel. After removing the wheel, put the horn wire through the hole and with the horn switch and retainer assembly located on the steering wheel hub secure the switch with the three screws. Connect the horn wire to its terminal, place the pivot splines of the master steering wheel hub and shaft over its hole and the press it down. Lastly, fit the steering wheel washer with self-locking nut screwed to the proper torque then, fit the horn button on the retainer turning clockwise or the pad by using the two screws.