×
- Live Chat
- 1-888-511-3595
My Garage
My Account
Cart
Genuine Chrysler Cirrus Door Latch Assembly
Door Latch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
8 Door Latch Assemblys found
Chrysler Cirrus Door Latch Assembly
Door Latch Assembly of Chrysler Cirrus is an important component of Chrysler Cirrus since it locks the doors to ensure that only the owner or the legal user has access to the inside of the car. This assembly can be operated to be either manual or automatic and the locks are independent or centrally locked. At Chrysler Cirrus it has used over the years, different styled Door Latch Assembly as most of them were made to be hard wearing and easy to open. Nevertheless, sometimes it is necessary to replace these components because of such problems as malfunctioning of outer door handles, sticking latches, troubles with the door lock button.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Chrysler Cirrus Door Latch Assembly at great affordable prices. Moreover, all genuine Chrysler Cirrus Door Latch Assembly come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Chrysler Cirrus Door Latch Assembly Parts Questions & Experts Answers
- Q: How to remove and install door latches, handles, and lock cylinders on Chrysler Cirrus?A: This procedure applies to both the front and rear doors. To remove the latch, first take off the door trim panel, ensuring that on vehicles with electric windows, the window is closed before disconnecting the electrical connectors. For manual windows, install the window crank without the retaining clip and roll up the window. If removing a rear door latch, also remove the window glass lower rear run channel. Next, disconnect the lock cylinder, lock button, and latch release operating rods from the door latch. For vehicles with power door locks, disconnect the electrical connector from the door lock motor. Remove the three mounting screws from the end of the door and take out the door latch. For installation, position the latch, install the screws, and tighten them securely. Connect the operating rods to the latch and secure with retaining clips, ensuring not to close the door until the latch is properly adjusted to avoid it not reopening. To adjust, insert a hex-wrench through the elongated hole near the latch, engage it in the socket head screw on the door latch linkage, and loosen it a couple of turns. Lift the outside door handle all the way up and then release it, followed by tightening the socket head screw and checking door operation. For the outside handle removal, take off the door trim panel, close the window on electric window vehicles, and for manual windows, roll up the window with the crank. If equipped with the Vehicle Theft Security System, remove the disarming switch from the door handle, disconnect the operating rod, remove the mounting nuts, and withdraw the handle from the door. Installation is the reverse of removal. For the lock cylinder, first remove the outside door handle, detach the operating rod retaining clip and operating rod from the lock cylinder, and if equipped with the Vehicle Theft Security System, remove the illuminated entry switch wiring clip and disconnect the electrical connector. Use a screwdriver to pry the lock cylinder retainer off and withdraw it from the door, with installation being the reverse of removal.
Related Chrysler Cirrus Parts
Chrysler Cirrus Door Lock Actuator
Chrysler Cirrus Dome Light
Chrysler Cirrus Door Lock Cylinder
Chrysler Cirrus Door Check
Chrysler Cirrus Door Handle
Chrysler Cirrus Door Hinge
Chrysler Cirrus Door Lock
Chrysler Cirrus Door Lock Switch
Chrysler Cirrus Door Moldings
Chrysler Cirrus Door Seal
Chrysler Cirrus Drain Plug