×
- Live Chat
- 1-888-511-3595
My Garage
My Account
Cart
Genuine Chrysler Sebring Hood Latch
Engine Hood Latch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
7 Hood Latches found
Chrysler Sebring Hood Latch
The Hood Latch which is used in Chrysler Sebring vehicles is important because it keeps the hood shut so that it does not open on the road. This component is crucial for protecting some of the important organs of the vehicle such as the engine, the radiator, as well as the battery. Chrysler Sebring models may also refer to different types of Hood Latch as are not all types defined such as the seal type and variation of the model. The main use of the Hood Latch functionality is to keep the hood shut while car is in use thus enhancing the safety of the car and its structural intergrity. The entire working of the hood latch contributes a lot into the efficiency and durability of Chrysler Sebring.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Chrysler Sebring Hood Latch at great affordable prices. Moreover, all genuine Chrysler Sebring Hood Latch come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Chrysler Sebring Hood Latch Parts Questions & Experts Answers
- Q: How to adjust and replace the hood latch and release cable on Chrysler Sebring?A: Disconnect the hood ajar sensor's electrical connector if present. Remove the bolts holding the hood latch to the radiator support and detach the latch. Adjust the hood's position by loosening the bolts and moving the latch. Detach the hood release cable and remove the latch. To install, reverse the removal process. Release the cable end and slide it into the hood latch's keyhole slot. Remove the cable from the latch. In the passenger compartment, detach the hood release cable and handle assembly. Remove the rubber cable insulator under the dash. Connect a string to the cable, detach it and pull it through the firewall. Connect the string to the new cable and pull it through the firewall. Reverse the removal process to complete the installation.
