How to Install an IAT Sensor on Jeep Patriot?

Unlock the retainers for the fresh air inlet duct, then disconnect the electrical connector from the Intake Manifold Temperature sensor. To remove the sensor, twist it counterclockwise and pull it out. Inspect the O-ring. Replace if cracked, torn or deteriorated. Installation is reverse of removal.

Genuine Jeep Patriot Intake Manifold Temperature Sensor

Air Intake Temperature Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

5 Intake Manifold Temperature Sensors found

View related parts
Jeep Patriot Sensor-Charge Air Temp
Part Number: 4606487AB
$63.83 MSRP: $96.10
You Save: $32.27 (34%)
ADD TO CART
Product Specifications
- Other Name: Sensor Charge Air Temp
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2007-2017 Jeep Patriot | Base 4WD, Base FWD, Latitude 4WD, Latitude FWD, Latitude X 4WD, Latitude X FWD, Limited 4WD, Limited FWD, Sport 4WD, Sport FWD | 4 Cyl 2.0L, 4 Cyl 2.4L
View related parts
Jeep Patriot Sensor-Air Temperature
Part Number: 5293138AA
$22.43 MSRP: $33.30
You Save: $10.87 (33%)
ADD TO CART
Product Specifications
- Other Name: Sensor Air Temperature
- Replaced by: 5149264AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2007-2009 Jeep Patriot | Base 4WD, Base FWD, Limited 4WD, Limited FWD | 4 Cyl 2.0L, 4 Cyl 2.4L
View related parts
Jeep Patriot Sensor-Air Temperature
Part Number: 5149264AB
$22.58 MSRP: $33.30
You Save: $10.72 (33%)
ADD TO CART
Product Specifications
- Other Name: Sensor Air Temperature
- Replaces: 5149264AA, 5293138AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2007-2017 Jeep Patriot | Base 4WD, Base FWD, Latitude 4WD, Latitude FWD, Limited 4WD, Limited FWD, Sport 4WD, Sport FWD | 4 Cyl 2.0L, 4 Cyl 2.4L
View related parts
Jeep Patriot Sensor-Charge Air Temp
Part Number: 5149209AA
$68.96 MSRP: $105.00
You Save: $36.04 (35%)
ADD TO CART
Product Specifications
- Other Name: Sensor Charge Air Temp; Air Intake Temperature Sensor, Sending Unit
- Replaces: 4862635AA, 5080343AA, 5174042AC, 5174042AB, 5174042AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2010-2014 Jeep Patriot | Base FWD, Latitude FWD, Sport FWD
View related parts
Jeep Patriot Sensor-Air Temperature
Part Number: 5149264AA
$22.43 MSRP: $33.30
You Save: $10.87 (33%)
ADD TO CART
Product Specifications
- Other Name: Sensor Air Temperature
- Replaced by: 5149264AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2010 Jeep Patriot | Base 4WD, Base FWD, Limited 4WD, Limited FWD, Sport 4WD, Sport FWD | 4 Cyl 2.0L, 4 Cyl 2.4L

Jeep Patriot Intake Manifold Temperature Sensor

The Intake Manifold Temperature Sensor which is used in Jeep Patriot vehicles is used to monitor the temperature of the air getting into the manifold chamber so that combustion efficiency can be well achieved in the engine mechanism. This data is sent to the Powertrain Control Module (PCM), which trims the fuel injector timing so as to achieve the correct air/fuel mixture while working under different conditions. Varying styles of Intake Manifold Temperature Sensors may be fitted in different models of the Jeep Patriot over the years, some of which may have been factory tuned for a particular airflow rate. An incorrect sensor may cause incorrect speed or an air/fuel mixture problems that bring about stalling and setting off of a Diagnostic Trouble Code (DTC) and, therefore, the CHECK ENGINE light. Periodic inspection of a particular air intake system is necessary, to allow avoiding the influence of unwanted air on the work of the engine.

Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Jeep Patriot Intake Manifold Temperature Sensor at great affordable prices. Moreover, all genuine Jeep Patriot Intake Manifold Temperature Sensor come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.

Jeep Patriot Intake Manifold Temperature Sensor Parts Questions & Experts Answers

Sensor-Air Temperature
5149264AB
Q: How to Install an IAT Sensor on Jeep Patriot?
A: Unlock the retainers for the fresh air inlet duct, then disconnect the electrical connector from the Intake Manifold Temperature sensor. To remove the sensor, twist it counterclockwise and pull it out. Inspect the O-ring. Replace if cracked, torn or deteriorated. Installation is reverse of removal.