×
- Live Chat
- 1-888-511-3595
My Garage
My Account
Cart
Genuine Jeep Patriot Oxygen Sensor
Oxygen O2 Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
4 Oxygen Sensors found
Jeep Patriot Oxygen Sensor
The Oxygen Sensor in Jeep Patriot vehicles helps in determining the air to fuel ratio in the engine exhaust so that efficiency can be regulated and emissions can be minimized. Due to the presence of the uniquely concentrated unburned oxygen and generating a voltage signal depending on it, the sensor enables the engine control computer to properly tune the air/fuel mix ratio. Rich or lean information is detected by utilizing a zirconium dioxide sensing element that has a layer of platinum; voltage signals are produced by the sensor to inform the computer of the air-fuel mixture ratio. Jeep Patriots usually have at least two oxygen sensors, the upstream one before the catalytic converter and the downstream one after the converter to feed back the accurate information to the vehicle. Aside from the traditional oxygen sensors, there are air/fuel ratio sensors normally used in newer designs for wider ranging measurements and these can be become contaminated and also weakened by age effects.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Jeep Patriot Oxygen Sensor at great affordable prices. Moreover, all genuine Jeep Patriot Oxygen Sensor come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Jeep Patriot Oxygen Sensor Parts Questions & Experts Answers
- Q: How Should I Be Particularly Careful When Servicing an Oxygen Sensor on Jeep Patriot?A: Be careful when servicing an oxygen sensor. Keep contaminants away from the electrical connector and louvered end. Avoid dropping or handling roughly. Make sure the silicone boot is installed correctly. Start and run the engine for a minute or two before attempting removal. For upstream sensor, remove engine cover, disconnect wire harness and connector. For downstream sensor, disconnect connector mounting clips, raise vehicle and support securely, disconnect connector from engine wiring harness, and remove sensor from catalytic converter. Installation is reverse of removal.
