Chrysler 4578050AA Bracket-Engine Mount

You can Select Your Vehicle to check if 4578050AA fits your vehicle.

For replacement, follow these steps: Disconnect the cable from the negative terminal of the battery. Raise the vehicle and support it securely on jackstands (if not already done). Position a jack under the engine oil pan with a large wood block between the jack head and the oil pan. If you're removing the right side engine mount, remove the alternator support bracket. Remove the engine mount-to-subframe nuts and raise the engine with the jack. Remove the mount-to-engine bracket bolts. Install the new mount, making sure it is correctly positioned in the bracket. Install the fasteners and tighten them securely.

Position two jacks, one under the crankshaft pulley and the other under the transmission bell housing. Place a block of wood between the jack head and the crankshaft pulley or bellhousing, then carefully raise the engine/transmission just enough to take the weight off the mounts.

Raising the engine slightly during the check is done to remove the weight from the mounts, allowing for a proper inspection.

Remove the engine mount and replace it with the new one. Tighten the upper bolts to the specified torque.

If movement is noted, lower the engine and tighten the mount fasteners. Rubber preservative should be applied to the mounts to slow down deterioration.

If movement is noted during the mount inspection, lower the engine and tighten the mount fasteners.