Chrysler 4861574AC Bracket-Engine Mount

You can Select Your Vehicle to check if 4861574AC fits your vehicle.

Access the left side transaxle mount through bolt using the hole in the inner fenderwell.

1. Remove the load on the engine mounts by carefully supporting the engine and transaxle assembly with a floor jack. 2. Loosen the right insulator vertical fasteners and the front engine mount bracket-to-front crossmember bolts and nuts. 3. The left engine mount insulator is sleeved over the shaft and long support bolt to provide lateral movement adjustment. 4. Pry the engine right or left as required to achieve the proper driveaxle length. 5. Securely tighten the right engine mount insulator vertical bolts, the front engine mount bolts and nuts, and center the left engine mount insulator. 6. Finally, recheck the driveaxle length.

Separate the assembly from the engine mount bracket and engine compartment.

The engine mounting system consists of four mounts: the right and left mounts support the engine/transaxle assembly, while the front and rear mounts control powertrain torque.

Inspect the mounts for cracks, hardening, or separation from the metal backing, and note any relative movement between the mount plates and the engine or frame.

Remove the bolt to separate the front engine mount from the block, noting that the starter must be removed for access.