Chrysler 56041584AF Sensor-CAMSHAFT

You can Select Your Vehicle to check if 56041584AF fits your vehicle.

Raise the front end of the vehicle and support it securely on jackstands. Disconnect the electrical connector from the CMP sensor by depressing the release tab and pulling off the connector. If applicable, detach the wiring harness clip from the CMP sensor mounting stud. Remove the sensor mounting bolt and take out the CMP sensor.

Remove the sensor mounting bolt and remove the CMP sensor.

For installation, carefully insert the sensor into the cylinder head, adjust the air gap, and tighten the mounting bolts. Clean the mounting bore, apply engine oil on the O-ring, and securely tighten the mounting bolt.

Inspect the CMP sensor O-ring for any damage and replace if necessary. Apply a small amount of clean engine oil to the sensor O-ring and use a rocking motion to install it into the sensor mounting bore. Ensure that the CMP sensor mounting flange is fully seated against the mounting surface. Inspect the old CMP sensor O-ring for damage and replace if needed. Apply engine oil to the O-ring and install it using a rocking motion. Make sure the CMP sensor mounting flange is fully seated. Check the O-ring for damage and apply engine oil before reinstalling the sensor. The remaining installation steps are the reverse of removal.