Chrysler 4656542AA Rear Coil Spring

You can Select Your Vehicle to check if 4656542AA fits your vehicle.

Installation is the reverse of the removal procedure, but make sure the coil springs are positioned properly against their upper mounts. Before tightening any of the suspension fasteners to the torque values, raise the rear axle to normal ride height with the floor jack(s). Install the wheel and lug nuts. Lower the vehicle and tighten the lug nuts to the torque.

Extend the damper rod and install the rubber bumper. Position the coil spring with the smaller coils going on first and carefully place it onto the damper shaft. Install the rubber bumper and push it all the way down. Install the upper spring seat and dust boot onto the damper shaft. Install the suspension support, aligning the support notch with the clevis bracket on the strut support. Install the nut and tighten it to the specified torque. Loosen the coil spring compressor(s) until the top coil is properly seated against the upper spring seat and suspension support. Relieve all tension from the spring compressor(s) and remove them from the coil spring. Finally, install the strut/spring assembly.