Chrysler R4671130 Starter Motor

You can Select Your Vehicle to check if R4671130 fits your vehicle.

Disconnect the cable from the negative terminal of the battery. Remove the starter motor. For a Bosch starter, remove the field terminal nut, disconnect the field terminal, and remove the washer. Remove the three solenoid mounting screws. Work the solenoid off the shift fork and detach it from the drive end housing. Installation is the reverse of removal. For a Nippondenso starter, if you're replacing the starter motor or solenoid, disconnect the field coil strap from the solenoid terminal. To detach the starter motor from the gear reduction assembly, remove the two long through-bolts and pull off the starter. To detach the solenoid from the gear reduction assembly, remove the starter, then remove the two Phillips screws from the gear reduction assembly and pull off the solenoid. Installation is the reverse of removal.

Start by detaching the cable from the negative terminal of the battery. Then, remove the upper mounting bolt and nut from above. Next, raise the vehicle and support it securely on jackstands. Disconnect the wires from the terminals on the starter motor and solenoid by removing the two nuts. After that, remove the lower mounting bolt and detach the starter.

The over-running clutch in the starter motor may be slipping, requiring replacement, or the teeth on the flywheel/driveplate may be broken.