Jeep RX033757AB ALTERNATR-Less PULLEY

You can Select Your Vehicle to check if RX033757AB fits your vehicle.

Installation is the reverse of removal, tightening the alternator mounting bolts to the torque.

Remove the engine cover, disconnect the field wire electrical connector, and remove the drive belt. Take out the two mounting bolts at the bottom of the alternator.

Loosen the right front wheel lug nuts, raise the front of the vehicle, and support it securely on jackstands. Remove the wheel and the under-vehicle splash shield. Also, pull back the front inner fender liner after removing its fasteners to create working space. Remove the drivebelt and the drivebelt idler pulley. Unplug the air conditioning compressor clutch electrical connector and move the compressor out of the way without disconnecting the lines, ensuring it's secured properly with wire or rope. Do not let the compressor hang by the refrigerant lines or electrical harness. Unplug the field connector from the alternator and remove the nut securing the B+ wire terminal on the back of the alternator. Remove the upper and lower alternator mounting bolts. Detach the alternator from its mounting bracket and maneuver it out from the bottom of the vehicle.