Jeep BBH34800AA Battery-Storage

You can Select Your Vehicle to check if BBH34800AA fits your vehicle.

Vehicle battery maintenance is crucial for starts. Ensure the battery tray and clamp fasteners are in good condition. Check the battery for damage. Use a slow-rate charger to restore or maintain battery charge.

Disconnect the negative battery cable first, then the positive cable. Check the battery state of charge and perform a load test. Replace the battery, disconnecting the cables in reverse order. Lift out the battery and inspect the area underneath for corrosion. Ensure the new battery matches the original's dimensions, amperage rating, and cold cranking rating. Reinstall the battery and reconnect the cables.

You should clean the cable clamps, terminals, and battery case with a solution of warm water and baking soda, taking care not to let the solution enter the battery.

Disconnect the negative cable first, then the positive cable. Remove the battery thermo-wrap, hold-down clamp, and lift out the battery. Replace it with a battery of identical specifications. When removing the battery tray, disconnect the hose from the vacuum reservoir, remove the mounting bolt and nuts, and lift up the tray while disconnecting the electrical connector from the battery temperature sensor. Wash the tray and reinstall it following the reverse of the removal process.

Disconnect the negative battery cable and visually inspect the battery's state of charge using the indicator eye (if equipped). Charge the battery or add distilled water if needed. Use a hydrometer to check the specific gravity of the electrolyte in each cell. Perform an open circuit voltage test using a digital voltmeter, ensuring the battery voltage is above 12.5 volts. Use a battery load tester to evaluate the battery's ability to handle heavy amperage draw during startup and accessories operation. Cold temperatures may slightly affect the minimum voltage requirements. To test for battery drain, disconnect all accessories and check the current drain using a digital ammeter. Normal drain is around 100 milliamps or less, while excessive drain can cause battery discharge.

To install the new battery, simply reverse the removal process.

A routine preventive maintenance program for the battery in your vehicle is essential for quick and reliable starts.

Disconnect the negative battery cable first, followed by the positive cable, to avoid shorting the battery.

Battery maintenance is crucial to prevent being stranded with a dead battery.

Disconnect the negative (-) battery cable from the negative (-) battery terminal first, then disconnect the positive (+) battery cable from the positive (+) battery terminal.