Jeep BK034600AA Battery-Storage

You can Select Your Vehicle to check if BK034600AA fits your vehicle.

Disconnect the negative cable first, then the positive cable. Remove the battery thermo-wrap, hold-down clamp, and lift out the battery. Replace it with a battery of identical specifications. When removing the battery tray, disconnect the hose from the vacuum reservoir, remove the mounting bolt and nuts, and lift up the tray while disconnecting the electrical connector from the battery temperature sensor. Wash the tray and reinstall it following the reverse of the removal process.

A routine preventive maintenance program for the battery is essential for quick and reliable starts.

If the battery tray is damaged, it should be repaired or replaced.

Disconnect the negative battery cable and visually inspect the battery's state of charge using the indicator eye (if equipped). Charge the battery or add distilled water if needed. Use a hydrometer to check the specific gravity of the electrolyte in each cell. Perform an open circuit voltage test using a digital voltmeter, ensuring the battery voltage is above 12.5 volts. Use a battery load tester to evaluate the battery's ability to handle heavy amperage draw during startup and accessories operation. Cold temperatures may slightly affect the minimum voltage requirements. To test for battery drain, disconnect all accessories and check the current drain using a digital ammeter. Normal drain is around 100 milliamps or less, while excessive drain can cause battery discharge.

When charging the battery, you should remove cell caps (if equipped) and cover the holes, then connect the charger leads and set the charger to 12 volts.

Check the battery state of charge using the indicator eye on the top of the battery and performing an open voltage circuit test with a voltmeter. Charge the battery if necessary.

To install the new battery, simply reverse the removal process.

Disconnect the negative (-) battery cable from the negative (-) battery terminal first, then disconnect the positive (+) battery cable from the positive (+) battery terminal.

Before servicing the battery, ensure that the engine and all accessories are turned off and disconnect the cable from the negative terminal.

Check the battery state of charge using the indicator eye on the top of the battery and performing an open voltage circuit test with a voltmeter. Charge the battery if necessary.