Jeep 5184498AJ Engine Cooling Water Pump

You can Select Your Vehicle to check if 5184498AJ fits your vehicle.

Remove the timing belt and water pump mounting bolts.

Remove the coolant reservoir tank, right side engine mount, engine mount block from the water pump, lower engine cover, right front wheel, inner fender splash shield, drivebelt, idler pulley, air conditioning compressor, bypass and lower radiator hoses, and water pump mounting bolts.

There are two ways to check the operation of the water pump while it's installed on the engine. If the pump is defective, it should be replaced with a new or rebuilt unit. Water pumps are equipped with weep or vent holes. If a failure occurs in the pump seal, coolant will leak from the hole. In most cases, you'll need a flashlight to find the hole on the water pump from underneath to check for leaks. If the water pump shaft bearings fail, there may be a howling sound at the front of the engine while it's running. With the engine off, shaft wear can be felt if the water pump pulley is rocked up-and-down.

Remove the air filter housing and thermostat.

Remove the timing belt and water pump mounting bolts. Inspect the water pump for damage and replace if needed. Scrape off old gasket material and install a new O-ring on the coolant inlet pipe. Place the new gasket on the water pump and install it, then press the pump assembly until the coolant inlet pipe seats properly. Install the pump-to-mounting bolts and refill the cooling system.

There are several ways to check the operation of the water pump while it's installed on the engine. If the pump is defective, it should be replaced with a new or rebuilt unit. Water pumps are equipped with weep or vent holes. If a failure occurs in the pump seal, coolant will leak from the hole. In most cases, you'll need a flashlight to find the hole on the water pump from underneath to check for leaks.

Disconnect the cable(s) from the negative battery terminal(s).