×
- Live Chat
- 1-888-511-3595
My Garage
My Account
Cart
Genuine Dodge Avenger Water Pump
H2O Pump- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
12 Water Pumps found
Dodge Avenger Engine Cooling Water Pump
Part Number: 5184498AJ$203.07 MSRP: $306.00You Save: $102.93 (34%)
Dodge Avenger Water Pump
This lies with the Water Pump in Dodge Avenger automobiles the circulation of coolant throughout engine water jackets for purposes of heating as a result of combustion. By doing so, it enables us to maintain an optimal heat so that the engine does not overheat and transfer heat to the radiator and then to the atmosphere. Conventional Dodge Avenger water pumps type is the belt while the new products can boast of electric water pumps, which help maximize the efficacy with the help of the disconnection of the coolant flow from the revolutions per minute. The water pumps used in Dodge Avenger have been notorious and over time, the manufacturers changed from using cast iron instead, aluminium. It also has a range of performance water pump to suit street engines through to fully race orientated set-ups with improved coolant flow and a low amp draw. Auxiliary electric water pumps have other advantages, including low, stable flow rate and a possibility to work after the engine has been turned off, which makes them suitable for high-rev, or custom applications.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Dodge Avenger Water Pump at great affordable prices. Moreover, all genuine Dodge Avenger Water Pump come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Dodge Avenger Water Pump Parts Questions & Experts Answers
- Q: How to Replace the Water Pump on My Dodge Avenger?A: Disconnect the negative battery cable from the remote ground terminal or battery. Set the parking brake, raise the front of the vehicle and support it securely on jackstands. Drain the cooling system. For the 2.4L four cylinder engine, remove the accessory drivebelt, accessory drivebelt splash shield, water pump pulley bolts, water pump pulley, and water pump mounting bolts. For the 2.7L V6 engine, remove the radiator fan assembly, accessory drivebelt, timing chain and guides, and water pump bolts. For the 3.5L V6 engine, remove the timing belt and water pump mounting bolts. For the 3.6L V6 engine, remove the Coolant Reservoir tank, right side engine mount, engine mount block from the water pump, lower engine cover, right front wheel, inner fender splash shield, drivebelt, idler pulley, air conditioning compressor, bypass and lower radiator hoses, and water pump mounting bolts. Clean the bolt threads and threaded holes in the timing case cover. Compare the new pump to the old one. Remove all traces of old gasket material or the O-ring seal. Clean the engine and water pump mating surfaces. Apply a thin coat of RTV sealant to the new water pump O-ring and position it in the groove on the back of the water pump. Install a new seal, then carefully mate the pump to the engine. Install the water pump mounting bolts and tighten them to the torque. The remainder of installation is the reverse of removal. Refill and bleed the cooling system. Run the engine and check for leaks and proper operation.
