Mopar BAUNV34650 Battery-Storage

You can Select Your Vehicle to check if BAUNV34650 fits your vehicle.

The average charging time typically takes 12 to 16 hours, but it should be determined by the charger's instructions.

When servicing the battery, precautions should be taken such as turning off the engine and accessories and disconnecting the cable from the negative terminal.

Disconnect the negative cable first, then the positive cable. Remove the battery thermo-wrap, hold-down clamp, and lift out the battery. Replace it with a battery of identical specifications. When removing the battery tray, disconnect the hose from the vacuum reservoir, remove the mounting bolt and nuts, and lift up the tray while disconnecting the electrical connector from the battery temperature sensor. Wash the tray and reinstall it following the reverse of the removal process.

Disconnect the negative battery cable and visually inspect the battery's state of charge using the indicator eye (if equipped). Charge the battery or add distilled water if needed. Use a hydrometer to check the specific gravity of the electrolyte in each cell. Perform an open circuit voltage test using a digital voltmeter, ensuring the battery voltage is above 12.5 volts. Use a battery load tester to evaluate the battery's ability to handle heavy amperage draw during startup and accessories operation. Cold temperatures may slightly affect the minimum voltage requirements. To test for battery drain, disconnect all accessories and check the current drain using a digital ammeter. Normal drain is around 100 milliamps or less, while excessive drain can cause battery discharge.

You can determine the state of charge of the battery by measuring the specific gravity with a hydrometer or checking the built-in hydrometer (if applicable), or by using a digital voltmeter to check the charge. A fully charged battery should read 12.6 volts or higher.

Ensure that you purchase one that is identical in dimensions, amperage rating, and cold cranking rating.

Monitor the battery regularly during charging to prevent overheating.

Make sure you get one that's identical, with the same dimensions, amperage rating, cold cranking rating, etc.

Perform a battery load test using a battery load tester. Make sure to follow the tool manufacturer's instructions and maintain the load for a maximum of 15 seconds.